The MRT Engineering 91U901P is a cat-back-style rear section for the S550 and later Mustang GT, specifically an axle-back exhaust that replaces the factory mufflers and rear piping behind the axle. It is hand-built from T304 stainless steel, uses 2.5-inch mandrel-bent tubing, and finishes in 4-inch polished T304 stainless tips. MRT positions this system as its loudest axle-back, ahead of its Sport Touring Exhaust, with a deep, traditional muscle car tone.
For Mustang GT owners who want a much stronger exhaust presence without replacing the full system, this axle-back offers a straightforward upgrade. MRT says the design improves exhaust flow for added performance and is voiced to suit the GT's V8, raising volume noticeably while keeping drone to a level the manufacturer calls noticeable but tolerable. It suits enthusiasts who want an aggressive sound at wide-open throttle and a corrosion-resistant stainless build.
Key Features
- Axle-back exhaust configuration
- Handcrafted from corrosion-resistant T304 stainless steel
- 2.5-inch mandrel-bent tubing
- 4-inch polished T304 stainless steel tips
- MRT's loudest axle-back, louder than the MRT Sport Touring Exhaust
- Deep, balanced muscle car exhaust note
- Drone described by MRT as noticeable but tolerable
- Increased exhaust flow for improved performance, per the manufacturer
- Black Ops matte black tip finish offered by MRT as an extra-cost option
- Compatible with MRT Part #92G155 plates for vehicles with factory Active or Dual Mode exhaust valves
Handcrafted T304 Stainless Steel Construction
MRT builds this axle-back by hand from T304 stainless steel, an alloy chosen for its resistance to corrosion. That matters on a component mounted at the rear of the car, where it is constantly exposed to road spray, moisture, and heat cycling.
The tubing is 2.5-inch diameter and mandrel bent, which keeps the pipe diameter consistent through each bend. The system terminates in 4-inch polished T304 stainless tips that match the material used throughout the rest of the assembly.
Performance and Benefits
MRT describes this as the loudest axle-back in its lineup, with a sound level above its Sport Touring Exhaust. The tone is deep and balanced in the classic muscle car style, and the system is tuned to complement the Mustang GT's engine. At cruise the drone is present, which MRT characterizes as noticeable but tolerable, so buyers should expect some resonance in exchange for the added volume.
Under wide-open throttle the exhaust gets considerably louder and takes on an aggressive performance note. MRT also states that the system provides increased performance through improved exhaust flow, though no specific horsepower or torque figures are given.
Installation
- For vehicles equipped with factory-installed Active or Dual Mode exhaust valves, MRT recommends its Part #92G155 plates, which allow the upgrade without developing a custom tune; these plates are a separate part
Why You Need This
- You want the loudest axle-back MRT offers for your Mustang GT
- You prefer a deep, traditional muscle car exhaust tone over a subdued factory sound
- T304 stainless steel construction resists corrosion for long-term durability
- 2.5-inch mandrel-bent tubing and improved flow support the GT's performance
- You want a significant sound upgrade without replacing the entire exhaust system
- Owners with Active or Dual Mode valves have a no-tune path using MRT Part #92G155 plates
Vehicle Fitment
- 2015-2026 Ford Mustang GT, Fastback & Convertible
What's Included
- T304 stainless steel axle-back assembly with 2.5-inch mandrel-bent tubing
- 4-inch polished T304 stainless steel tips
Not included:
- MRT Part #92G155 plates for Active and Dual Mode exhaust valve vehicles (sold separately)