Milltek's active valved cat-back for the 2026 Mustang GT Fastback, part number SSXFD427, swaps out the factory resonators and mufflers for a T304 stainless steel system. It uses an X-pipe crossover and finishes with quad tips in a brushed titanium finish. The goal is a sharper, clearer exhaust note and less restriction than the stock H-pipe layout, while keeping the factory active exhaust valves working.
The system bolts directly to 5.0L Coyote-powered GT Fastbacks equipped with the factory active exhaust and works with both manual and automatic transmissions. It suits street-driven builds that already run, or plan to add, a cold air intake, tune, or headers. Because the OEM valve system stays functional, you can still switch between a subdued and a more aggressive sound through the drive modes. The tips are styled to look understated rather than flashy.
Key Features
- Part number SSXFD427
- T304 stainless steel construction
- X-pipe midsection in place of the factory H-pipe
- Quad tips with a brushed titanium finish
- Replaces the factory resonators and mufflers
- Works fully with the OEM active exhaust valve system for quiet, cruise, and loud modes
- Reuses the factory valve motors and actuators, so no extra components are needed
- Saves weight over stock through reduced muffler mass and more efficient pipe routing
- Direct bolt-on fitment with no cutting, welding, or fabrication
- No tuning or recalibration required
- Compatible with manual and automatic transmissions
T304 Stainless Steel Construction with Brushed Titanium-Finish Tips
Milltek builds the system from T304 stainless steel, which is chosen to handle daily driving, repeated heat cycles, and road grime without giving up flow or strength. The pipe routing is designed to be more efficient than the factory layout. Together with the reduced muffler mass, that routing saves weight compared with the stock cat-back.
The system ends in four tips with a brushed titanium finish. Milltek describes them as corrosion-resistant and motorsport-inspired, with a restrained OEM+ appearance.
Performance and Benefits
Removing the factory resonators and mufflers is intended to reduce restriction and improve throttle response. The X-pipe crossover is designed to give a cleaner, more exotic sound with better clarity at high RPM than the stock H-pipe. Milltek describes the tone as crisp and Euro-style: refined under load, aggressive at wide-open throttle, and without drone.
Because the system keeps the OEM active valves, sound remains adjustable through the drive modes. You can open the valves on command or keep things quiet, for example during cold starts.
Milltek notes that the best results come from pairing this cat-back with headers or high-flow mid-pipes. Peak output should not be expected with the stock manifolds.
Installation
- Direct bolt-on; no cutting, welding, or fabrication required
- Reuses the OEM active exhaust valve actuators
- No tuning or recalibration required
- Professional installation recommended to ensure proper fit and correct valve motor positioning
Why You Need This
- Swap the factory H-pipe, resonators, and mufflers for a T304 stainless X-pipe system aimed at a sharper tone and better flow
- Keep drive mode sound control, since the factory active valves stay fully functional
- Install without cutting, welding, or retuning the vehicle
- Lose some weight compared with the stock cat-back
- Build on existing or planned intake, tune, or header upgrades with a complete cat-back system rather than a mix of separate parts
Vehicle Fitment
- 2026 Ford Mustang GT (5.0L), Fastback
Fitment notes:
- Not compatible with convertibles due to chassis and clearance differences