The MagnaFlow 19103 is a Competition Series axle-back exhaust kit for non-active-exhaust Mustang GT models. It is built entirely from stainless steel and uses mandrel-bent 3 inch tubing, a pair of 5 inch by 14 inch mufflers, and 4-1/2 inch polished exhaust tips. It replaces the factory system from the axle rearward and gives the Coyote V8 a deeper, more assertive voice than the stock setup.
The kit is aimed at GT owners who find the factory exhaust note too subdued and want a stronger V8 rumble without replacing the whole system. MagnaFlow states that the kit has been dyno tested and shows gains in both horsepower and torque. Because the construction is stainless steel throughout, the system should hold its appearance over time. The included hardware and instructions keep the install manageable for enthusiasts who do their own work, although the factory piping must be cut before the new components bolt in.
Key Features
- MagnaFlow Competition Series axle-back exhaust kit, part number 19103
- Full stainless steel construction
- Mandrel-bent 3 inch tubing
- Two 5 inch by 14 inch mufflers
- 4-1/2 inch polished exhaust tips
- Dyno tested by the manufacturer, which reports gains in horsepower and torque
- Designed for non-active-exhaust Mustang GT applications in Fastback and Convertible body styles
- Hardware and installation instructions included
Full Stainless Steel Construction with Mandrel-Bent 3 Inch Tubing
MagnaFlow builds this Competition Series axle-back entirely from stainless steel, as it does with all of its exhaust systems. Stainless steel helps the system keep its finish and appearance for years after installation.
The 3 inch tubing is mandrel bent. This process forms each bend without crimping or narrowing the pipe, so the tubing keeps a consistent diameter through every curve. The system ends in a pair of 5 inch by 14 inch mufflers that carry 4-1/2 inch polished tips.
Performance and Benefits
The kit is tuned to deliver what MagnaFlow calls its signature V8 muscle car rumble. It is intended for owners who feel the factory exhaust note is too restrained for a V8 GT.
MagnaFlow reports that the system was dyno tested and produced gains in both horsepower and torque. The manufacturer does not publish specific figures in the product information.
Installation
- Installation requires cutting the factory exhaust piping.
- After the factory system has been modified, the new axle-back installs with a bolt-in procedure.
- All necessary hardware and instructions are included with the kit.
Why You Need This
- Gives the V8 a fuller rumble than the factory exhaust
- Full stainless steel construction helps the system keep its appearance over time
- Mandrel-bent 3 inch tubing keeps the pipe diameter consistent through the bends
- Dyno tested by MagnaFlow, which reports horsepower and torque gains
- 4-1/2 inch polished tips give the rear of the car a clean, finished look
- Hardware and instructions are included, so the install can be done at home once the factory pipe is cut
Vehicle Fitment
- 2024 Ford Mustang GT, Fastback & Convertible
What's Included
- Mandrel-bent 3 inch stainless steel tubing
- Two 5 inch by 14 inch mufflers
- 4-1/2 inch polished exhaust tips
- All necessary hardware
- Installation instructions